I n d i c a t o r L i g h t A s s e m b l y ( A 8 ) , Replacement.

TM 32-5865-061-24&P

e . L a b e l a n d u n s o l d e r t h e c o n n e c t i o n t o g r o u n d terminal E1.

R e m o v e and retain the six screws and w a s h e r s s e c u r i n g t h e a s s e m b l y c o v e r .

Lift off the cover.

Label and unsolder the output connection to FL-1, FL-2, and E2.

Slip the wires through the grommet and remove the assembly from the unit.

NOTE

When a defective EMI filter is to be stored for later repair, the

cover and screws retained in step e. should be replaced.

i. To install a replacement, reverse the procedure detailed in steps a. thru

h. above.

T h i s assembly is mounted on

5 - 4 . 9 I n d i c a t o r L i g h t A s s e m b l y ( A 8 ) , Replacement.

t h e f r o n t p a n e l . Replace a faulty assembly as described in the following subpara-

graphs.

NOTE

Individual indicator lights can be replaced

without

removing

the

assembly from the unit. Refer to para 5-7.

Removal.

Remove the defective assembly from the unit as follows:

Refer to para 5-4.1 for procedure.

R e m o v e the bottom access cover.

Remove and retain the four countersunk screws securing the assembly to the

front panel.

c. Label and unsolder all wires connected to the assembly.

T h e assembly may now be removed from the unit through the bottom access

cover.

I n s t a l l a replacement assembly a s

follows:

5-4.9.2

Installation.

a. Remove and retain the four pan-head screws from t h e f r o n t o f t h e

replacement assembly.

Solder the connecting wires to the terminals on the assembly.

P o s i t i o n the assembly behind the front panel and secure using the hardware

d. Replace and secure the bottom access cover.

Ensure the assembly is fitted with serviceable lamps. Refer to para 5-7.

Install the four pan-head screws retained in step a. above in the defective

Repair as described in para 5-7.

assembly.

5-13