Auto-step sequence mode activation

TM 11-5865-215-13

(b) Press RCL key and observe that it lights.

sired sequence of stored receiver commands according to

A8, B8, and A2 are to be preset in sequence, entries must

be made in order shown in table 3-2. As many as 31 com-

binations of the 20 programmed receiver commands may be

preset in this manner.

(d) To verify preset sequence, press RCL key, then press and

release the AUTO STEP key repeatedly to manually step

through the sequence. Observe that correct register key

is lit during each step.

NOTE

To erase the entire preset sequence, press RCL key,

then the CLR key twice.

(2) Auto-step sequence mode activation.

--.

Observe that AUTO STEP and HOLD

(a) Press AUTO STEP key.

keys light.

(b) Press START key. Observe that START key lights and the

HOLD key goes out. In addition, the register file number

and associated receiver command is displayed on the key-

board according to the preset stepping sequence.

NOTE

If an AUTO STEP sequence has not been previously set,

the START and HOLD keys will flash. This flashing

is stopped by pressing the CLR key.

Sequence Presetting Example

Table 3-2.

Resulting

Press

step sequence

Press

DATA A/DATA B

Press

STO

1st step = Register A9

RCL

STO

2nd step = Register B9

RCL

STO

3rd step = Register A8

RCL

STO

4th step = Register B8

RCL

STO

5th step = Register A2

RCL

3-9