|
|
TM 32-5865-061-24&P
Section V. TROUBLESHOOTING
t e s t . When the symptom is identified as a faulty Receiver Set inform Direct
S u p p o r t ( D S ) . R e f e r to TM 32-5865-060-10 for the BITE procedure. Troubleshooting
allocated to General Support (GS) shall be in accordance with the MAC.
Section VI. MAINTENANCE OF RECEIVER SET
2-6. SCOPE. This section describes the tasks allocated to organizational
These tasks are accomplished without
m a i n t e n a n c e personnel by the MAC.
dismantling the unit.
2 - 7 . M A I N T E N A N C E O F R E C E I V E R S E T . The maintenance of the Receiver Set is limited
t o t h e t a s k s d e t a i l e d i n t h i s p a r a g r a p h . I f t h e R e c e i v e r S e t is found to be
faulty, inform DS.
Inspection.
Inspect the Receiver Set as follows:
a . I n s p e c t f o r a c c u m u l a t i o n s o f d u s t , g r e a s e , a n d f o r d a m a g e to paint work.
For damaged
C h e c k that e x t e r n a l components are secure and undamaged.
b.
components report to D.S.
Adequate ventilation should be provided while using TRICHLOROTRI-
P r o l o n g e d breathing of vapor should be avoided. The
FLUOROETHANE.
s o l v e n t should not be used near heat or open flame; the products of
decomposition are toxic and irritating.
Since TRICHLOROTRIFLUOROE-
T H A N E dissolves natural oils, prolonged contact with skin should be
W h e n necessary, u s e g l o v e s w h i c h t h e s o l v e n t c a n n o t
avoided.
If the solvent is taken internally, consult a physician
penetrate.
immediately.
2 - 7 . 2 C l e a n i n g . The exterior of the unit should be free of dirt, dust, grease,
m o i s t u r e , f u n g u s , r u s t a n d c o r r o s i o n . Clean as follows:
a. Remove dust, dirt, and moisture with a clean soft cloth.
b . Remove grease, fungus and ground-in dirt from equipment covers using a
cloth dampened (but not wet) with trichlorotrifluoroethane available as
F r e o n type TF, NSN 6850-00-105-3084.
c. Remove dust and dirt from plugs and jacks with a brush.
d.
Clean air filters using a stiff brush.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |