Slide-Mount Installation.

TM 11-5865-215-13

2-5.

Although the receiver control is not supplied with slide assem-

blies, the following steps can be used as a general guide for install-

ing the unit on slides:

Remove outer rail from each chassis slide of support. assembly.

With one person at front of rack and one at rear, position,

chassis slide and support assembly as desired and secure slots on

front of each rail to front. panel mounting brackets of rack with 10-32

x 1/2 inch screws and no. 10 flat washers. Use Loctite grade A on

threads.

Secure each side of chassis slide and support assembly to rear

of rack with 10-32 x 3/4 inch screws and no. 10 flat washers. Use

Loctite grade A on threads.

d. Secure chassis slide and support assembly units to each side

of receiver control chassis using 10-32 x 1/2 inch screws and no. 10

flat washers.

Mount unit on slides and fasten front panel to rack with cap-

tive screws located on front panel.

2-6.

The receiver control is connected to other components as described

in TM 11-5865-217-23 and TM 11-6625-2898-13.