Chapter 2. SERVICE UPON RECEIPT AND INSTALLATION

TM 11-5865-215-13

SERVICE UPON RECEIPT AND INSTALLATION

Section I.

SERVICE UPON RECEIPT OF MATERIAL

Unpacking.

When packed for shipment, the receiver control is wrapped with

plastic and placed in a cardboard container. Fiberboard blocking

material is provided to minimize shock during transport. The pro-

cedure for unpacking the unit is obvious upon inspection.

Checking Unpacked Equipment.

2-2.

a. Inspect the equipment for damage incurred during shipment. If

the equipment has been damaged, report the damage on DD Form 6 (Report

of Packaging and Handling Deficiencies) as prescribed in AR 700-58.

b. Check the equipment against the component listing on the pack-

ing slip to see if the shipment is complete. Report all discrepancies

in accordance with paragraph 1-3. The equipment should be placed in

service even if a minor assembly or part that does not. affect proper

functioning is missing.

(Modified

c. Check to see if tile equipment has been modified.

equipment will have the MWO number on the front panel near the nomen-

clature plate.) Check also to see whether all currently applicable

MWOs have been applied (Current MWOs pertaining to the equipment are

listed in DA PAM 310-7.)

d. For dimensions, weights, and volume of packaged items, see

SB 700-20.

INSTALLATION INSTRUCTIONS

Section II.

Tools, Test Equipment, and Materials Required for installation.

test equipment, or materials are required to install

No tools,

the receiver control.

Installation.

2-4.

The receiver control is a self-contained unit and is fully equipped

for rack-mounting, shelf-mounting, or bench-top installation. If

slide-mounting is required, perform the procedures in paragraph 2-5.