Section I. INTRODUCTION - TM-11-5826-219-35P0002

SECTION I

INTRODUCTION

(1) Source code indicates the selection

1. Scope

This manual lists repair parts and special tools codessare: source for the listed item. Source

statu and

required for the performance of direct support,

general support, and depot maintenance of the Code

Explanation

R-1041/ARN, R--1041A/ARN, and R-104lB/

Repair parts which are stocked in or supplied from

ARN.

the GSA/DSA, or Army supply system and author-

ized for use at indicated maintenance categories.

2. General

Repair parts which are procured and stocked for

insurance purposes because the combat or mili-

This Repair Parts and Special Tools List is

tary essentiality of the end item dictates that

divided into the following sections:

a minimum quantity be available in the supply

a. Repair Parts -- Section II. A list of re-

system.

pair parts authorized for the performance of

Assigned to items which are NSA design controlled:

maintenance at the direct support, general

unique repair parts, special tools, test, measuring

and diagnostic equipment, which are stocked and

support, and depot level.

supplied by the Army COMSEC logistic system,

b. Special Tools, Test and Support Equip-

and which are not subject to the provisions of

ment -- Section III. Not applicable.

AR 380-41.

NOTE

Assigned to items which are NSA design controlled:

P10

special tools, test, measuring and diagnostic equip-

All indexes noted below are cross refer-

ment for COMSEC support, which are accountable

enced to index numbers. The index

under the provisions of AR 380-41, and which are

numbers appear in ascending sequence

stocked and supplied by the Army COMSEC

logistic system.

in column 1 of the repair parts list. The

Repair parts which are not procured or stocked, but

index number for the particular item will

are to be manufactured in indicated maintenance

be the same for the item in all sections

levels.

of this publication.

Assemblies which are not procured or stocked as

such, but are made up of two or more units. Such

c. Federal Stock Number Cross Reference

component units carry individual stock numbers

to Index Number -- Section IV. A list of Fed-

and descriptions, are procured and stocked sep-

eral stock numbers in ascending numerical

arately and can be assembled to form the required

assembly at indicated maintenance categories.

sequence cross referenced to index (sequence)

numbers.

Parts and assemblies which are not procured or

stocked and the mortality of which normally is

d. Figure and Item Number Cross Reference

below that of the applicable end item or component.

to Index Numbers --Section V. A list of illustra-

The failure of such part or assembly should result

tion figure numbers in numerical sequence, cross

in retirement of the end item from the supply

system.

referenced to item number (reference designa-

tion) and index numbers.

Repair parts which are not procured or stocked. The

requirement for such items will be tilled by use of

e. Reference Designation Cross Reference to

the next higher assembly or component.

Index Number -- Section VI. A list of reference

Repair parts which are not stocked. The indicated

d e s i g n a t i o n s (or item numbers) to index

maintenance category requiring such repair parts

numbers.

will attempt to obtain same through cannibaliza-

tion. Where such repair parts are not obtainable

through cannibalization, requirements will be req-

uisitioned,

with accompanying justification,

3. Explanation of Columns

through normal supply channels.

The following provides an explanation of columns

Major assemblies that are procured with PEMA funds

for initial issue only as exchange assemblies at

in the tabular lists.

DSU and GSU level. These assemblies will not be

a. Source, Maintenance, and Recoverability

stocked above DS and GS level or returned to

Codes (SMR), Column 1.

depot supply level.